OBJECTIVE: To evaluate dose-area product, skin entrance dose and doses from fluoroscopy and radiography in voiding cystourethrography studies of pediatric patients. MATERIALS AND METHODS: Procedures performed in 37 patients by four physicians of the institution were evaluated. Measurements were performed with an equipment including an ionization chamber directly coupled to the x-ray tube window and an electrometer (Diamentor) connected to a computer for data collection. RESULTS: Some procedures heterogeneity was observed and guidelines for good radiographic techniques were not followed. On average, 11 radiographies are performed for each study, with extended fluoroscopy time delivering a higher average final dose than those reported in the literature. CONCLUSION: The adoption of radiography with high kilovoltage technique and restricted utilization of fluoroscopy can result in a significant reduction of doses during this procedure, considering that the major contribution to the final dose comes from fluoroscopy.

Keywords: X-rays, Dosimetry, Cystourethrography, Fluoroscopy, Pediatric radiology

OBJECTIVE: Entrance skin dose, effective dose, and imaging quality in chest radiographs of adult patients have been evaluated. MATERIALS AND METHODS: The study has been developed in eight institutions - seven public hospitals (two of them philanthropic institutions) and one private - in the cities of Agra dos Reis, Cabo Frio, Campos dos Goytacazes, Itaperuna, Niterói, Recife and Rio de Janeiro. Entrance skin dose and effective dose have been evaluated in 735 chest radiographs obtained in posteroanterior/anteroposterior and lateral projections. As regards imaging criteria, 44 radiographs have been evaluated. RESULTS: Variations of up to nine times in entrance skin dose, and six times in effective dose have been detected for a same type of projection. Also, significant discrepancies have been found in values resulting from radiographic techniques employed. Besides, imaging quality has not been good since the rate of compliance with imaging criteria was only 55%. CONCLUSION: There is a pressing need for improvement/standardization of procedures in conventional radiology; this can be achieved by implementing a quality control and assurance program in the department of radiology, including training of technicians, x-ray equipment calibration, and sensitometric control of films processors.

Keywords: Chest x-ray, Quality control, Dosimetry

OBJECTIVE: This study aims to evaluate the effective ionizing radiation dose received by staff involved in interventional vascular procedures to establish parameters for comparison between the data obtained with an ionization chamber and with the dosimeters used for individual monitoring. MATERIALS AND METHODS: The evaluation was performed in a cardiac catheter laboratory and air kerma rate was measured in a real working environment, in the positions occupied by physicians and nurses, with and without the lead glass shield. The number of tests performed in the laboratory was taken into consideration and most common projections and radiographic parameters were selected. Conversion factors founded in the literature were applied for the effective dose estimation. RESULTS: The values found in the effective dose and in the dosimetry report were rather consistent. Additionally, it was observed that the use of the lead glass shield reduces in up to 97% the doses received by the professional and therefore it must be routinely used. CONCLUSION: The reported values are representative but cannot be assumed as a reproduction of individual monitoring conditions, although they are valid for comparison purposes and as a guidance for dosing optimization.

Keywords: Occupational exposure, Dosimetry, X-rays, Hemodynamics

OBJECTIVE: To present the solidly established traceability structure for ionometric standards and for thermoluminescent dosimetry system that ensures reliability of the Dosimetry Quality Assurance Program and is aimed to certify the highest level of accuracy of the measurements. MATERIALS AND METHODS: Thermoluminescent powder dosimeters (DTL 937) placed into plastic capsules and packed in specific kits for each intended application were mailed to the participant centers. RESULTS: The results of the intercomparisons performed between "Laboratório de Ciências Radiológicas da Universidade do Estado do Rio de Janeiro" and EQUAL-ESTRO for the beam of 60Co gamma rays, expressed for (1sigma), and the results of the dose absorbed measurements obtained with the chambers of the Program EQUAL and the chambers of the Dosimetry Quality Assurance Program were lower than 0.5%. CONCLUSION: Based on these results we concluded that the Dosimetry Quality Assurance Program reached the desired level of reliability to allow its implementation.

Keywords: Quality assurance, Radiotherapy, Dosimetric intercomparison, Thermoluminescent dosimetry, TLD

A choking patient was admitted with dyspnea, cyanosis, and loss of consciousness, which initially improved after suction of the airways. The patient presented worsening of the clinical parameters until the introduction of supportive treatment, after which she rapidly recovered. Chest x-ray taken on day of hospitalization showed bilateral diffuse alveolar filling pattern, and computed tomography showed ground glass areas. The aim of this paper is to show the radiological features of this syndrome.

Keywords: Mendelson syndrome, Chest x-ray, Computed tomography

An occupational monitoring program in diagnostic radiology was implemented at the "Hospital Universitário Clementino Fraga Filho - UFRJ", Rio de Janeiro, Brazil, in accordance with the Brazilian legislation. Previously, a survey of all personnel involved with ionizing radiation was performed. Many problems were observed: the great majority of the workers were not properly monitored; only three departments of the hospital kept an independent survey of the occupational doses; there was not a follow-up control of the high doses. With the implementation of the program, a new laboratory was chosen to read the dosemeters and this initiative resulted in reduction of the hospital costs. The inclusion of seven more departments in the program represented an increase of 60% in the number of monitored workers. The program also provided a system to control the high doses, especially in the Hemodynamics department, which presented the highest mean dose value (0.32 mSv/month). An area survey program was performed during different periods in places considered of high risk for the workers and for the public as well. At the same time, a software was used to build a database with the aim of controlling all personnel data. The implementation of the program provided all personnel involved a better knowledge of the risks associated with ionizing radiation and of radioprotection, and also awareness of the need of correct use of the personal dose monitors.

Keywords: Radiological protection, Occupational exposure, Quality control, Radiation dosimetry, Radiology

The authors report a case of a 4-year-old girl with headache, irritability, otorrhea, and unilateral exophthalmus. Computed tomography and plain films showed large lytic areas in the vault and base of the skull. No other bones were involved. The diagnosis of histiocytosis X (Hand-Schuller-Christian disease) was confirmed by bone marrow biopsy. This paper presents the cytological and radiological findings of this patient as well as a review of the literature.

Keywords: Histiocytosis, Histiocytosis X, Hand-Schuller-Christian, Skull

We present the quality control tests performed on a monophasic X-ray equipment and on two noninvasive monitoring systems. The results were compared with the values obtained using an invasive monitoring system and a hyperpure germanium detector, providing correction factors for utilization of the noninvasive voltage meters in the quality control program of X-ray equipment. We concluded that there is a need for periodic calibration and control.

Keywords: X-radiation, Quality control, Noninvasive systems

We developed a Tandem system using a pair of ionization chambers (a cylindrical and a parallel-plate type) to perform X-ray measurements in a medical Institution, in substitution of the routine conventional procedure of determination of half-values layers using absorbers. The results obtained indicate the possibility of application of this method in dosimetric procedures of orthovoltage beams (radiotherapy) as a complementary procedure in a quality control program.

Keywords: X-rays, Ionization chambers, Quality control

Objective: To evaluate the light and radiation fields congruence and radiation beam alignment in medical X-ray equipment in Paraíba state radiology centers by means of two quality control tests. Materials and Methods: A loaded cassette, a measuring tape and a bubble level were utilized in the field size and alignment testing. The evaluation of collimation systems accuracy and X-ray beam alignment was undertaken during health inspections performed in radiology centers between 2008 and 2009. Results: In 2008, 121 X-ray machines were evaluated in the Paraíba state. In 2009, 117 machines were tested. From this universe, 86 machines were selected for comparison, since they were evaluated both in 2008 and 2009, with 18.60% (n = 16) showing test results improvement from one year to another. Conclusion: The percentage of problematic X-ray machines decreased between 2008 and 2009, notwithstanding no quality assurance program has been observed in Paraíba state radiology centers.

Keywords: Equipment; X-rays; Quality control.

OBJECTIVE: The authors have sought to study the calibration of a clinical P_KA meter (Diamentor E2) and a calibrator for clinical meters (PDC) in the Laboratory of Ionizing Radiation Metrology at Instituto de Energia e Ambiente - Universidade de São Paulo. MATERIALS AND METHODS: Different qualities of both incident and transmitted beams were utilized in conditions similar to a clinical setting, analyzing the influence from the reference dosimeter, from the distance between meters, from the filtration and from the average beam energy. Calibrations were performed directly against a standard 30 cm³ cylindrical chamber or a parallel-plate monitor chamber, and indirectly against the PDC meter. RESULTS: The lowest energy dependence was observed for transmitted beams. The cross calibration between the Diamentor E2 and the PDC meters, and the PDC presented the greatest propagation of uncertainties. CONCLUSION: The calibration coefficient of the PDC meter showed to be more stable with voltage, while the Diamentor E2 calibration coefficient was more variable. On the other hand, the PDC meter presented greater uncertainty in readings (5.0%) than with the use of the monitor chamber (3.5%) as a reference.

Keywords: Kerma; Meters; Calibration; Dosimetry; Radiology; X-rays.

OBJECTIVE: Aiming at contributing to the knowledge on doses in computed tomography (CT), this study has the objective of determining dosimetric quantities associated with pediatric abdominal CT scans, comparing the data with diagnostic reference levels (DRL). MATERIALS AND METHODS: The study was developed with a Toshiba Asteion single-slice CT scanner and a GE BrightSpeed multi-slice CT unit in two hospitals. Measurements were performed with a pencil-type ionization chamber and a 16 cm-diameter polymethylmethacrylate trunk phantom. RESULTS: No significant difference was observed in the values for weighted air kerma index (C_W), but the differences were relevant in values for volumetric air kerma index (C_VOL), air kerma-length product (P_KL,CT) and effective dose. CONCLUSION: Only the C_W values were lower than the DRL, suggesting that dose optimization might not be necessary. However, P_KL,CT and effective dose values stressed that there still is room for reducing pediatric radiation doses. The present study emphasizes the importance of determining all dosimetric quantities associated with CT scans.

Keywords: Pediatric computed tomography scans; Dosimetric quantities; Weighted dose index; Volumetric air kerma index; Air kermalength product.

OBJECTIVE: This article presents a way to obtain estimates of dose in patients submitted to radiotherapy with basis on the analysis of regions of interest on nuclear medicine images. MATERIALS AND METHODS: A software called DoRadIo (Dosimetria das Radiações Ionizantes [Ionizing Radiation Dosimetry]) was developed to receive information about source organs and target organs, generating graphical and numerical results. The nuclear medicine images utilized in the present study were obtained from catalogs provided by medical physicists. The simulations were performed with computational exposure models consisting of voxel phantoms coupled with the Monte Carlo EGSnrc code. The software was developed with the Microsoft Visual Studio 2010 Service Pack and the project template Windows Presentation Foundation for C# programming language. RESULTS: With the mentioned tools, the authors obtained the file for optimization of Monte Carlo simulations using the EGSnrc; organization and compaction of dosimetry results with all radioactive sources; selection of regions of interest; evaluation of grayscale intensity in regions of interest; the file of weighted sources; and, finally, all the charts and numerical results. CONCLUSION: The user interface may be adapted for use in clinical nuclear medicine as a computer-aided tool to estimate the administered activity.

Keywords: Nuclear medicine; Biokinetic distribution; Dosimetric evaluations; Administered activity.

OBJECTIVE: Derive filtered tungsten X-ray spectra used in digital mammography systems by means of Monte Carlo simulations. MATERIALS AND METHODS: Filtered spectra for rhodium filter were obtained for tube potentials between 26 and 32 kV. The half-value layer (HVL) of simulated filtered spectra were compared with those obtained experimentally with a solid state detector Unfors model 8202031-H Xi R/F & MAM Detector Platinum and 8201023-C Xi Base unit Platinum Plus w mAs in a Hologic Selenia Dimensions system using a direct radiography mode. RESULTS: Calculated HVL values showed good agreement as compared with those obtained experimentally. The greatest relative difference between the Monte Carlo calculated HVL values and experimental HVL values was 4%. CONCLUSION: The results show that the filtered tungsten anode X-ray spectra and the EGSnrc Monte Carlo code can be used for mean glandular dose determination in mammography.

Keywords: Mammography; X-ray spectra; HVL; Monte Carlo.

In the appropriate clinical setting, certain aspects of extranodal abdominal lymphoma, as revealed by current cross-sectional imaging techniques, should be considered potentially diagnostic and can hasten the diagnosis. In addition, diagnostic imaging in the context of biopsy-proven lymphoma can accurately stage the disease for its appropriate treatment. The purpose of this article was to illustrate the various imaging aspects of extranodal lymphoma in the abdomen.

Keywords: Lymphoma; Abdomen; Tomography, X-ray computed.