OBJECTIVE: Entrance skin dose, effective dose, and imaging quality in chest radiographs of adult patients have been evaluated. MATERIALS AND METHODS: The study has been developed in eight institutions - seven public hospitals (two of them philanthropic institutions) and one private - in the cities of Agra dos Reis, Cabo Frio, Campos dos Goytacazes, Itaperuna, Niterói, Recife and Rio de Janeiro. Entrance skin dose and effective dose have been evaluated in 735 chest radiographs obtained in posteroanterior/anteroposterior and lateral projections. As regards imaging criteria, 44 radiographs have been evaluated. RESULTS: Variations of up to nine times in entrance skin dose, and six times in effective dose have been detected for a same type of projection. Also, significant discrepancies have been found in values resulting from radiographic techniques employed. Besides, imaging quality has not been good since the rate of compliance with imaging criteria was only 55%. CONCLUSION: There is a pressing need for improvement/standardization of procedures in conventional radiology; this can be achieved by implementing a quality control and assurance program in the department of radiology, including training of technicians, x-ray equipment calibration, and sensitometric control of films processors.

Keywords: Chest x-ray, Quality control, Dosimetry

OBJECTIVE: To evaluate the biosafety aspects and the working conditions of radiology department professionals and to make recommendations with respect to necessary modifications to be implemented in these departments in order to comply with national regulations. MATERIALS AND METHODS: Interviews with the professionals were carried out as well as observation of their activities in the working premises including processing of radiographic films inside the dark rooms, average time inside the dark rooms, preparation of chemical solutions for automatic processors and the type of help given to patients during radiographic examinations. The efficiency of the exhausting systems in the dark rooms was also measured. The ergonomic adequacy of the accessories inside the dark rooms was analyzed. With respect to electrical safety, the location and number of fire extinguishers as well as the grounding of the electrical equipment was evaluated to check if they were in accordance with the Brazilian legislation. RESULTS: The exhaustion systems were insufficient, professionals did not wear protective clothes/devices when preparing the chemical solutions, the ergonomic aspects were not in accordance with national recommendations, and the workers presented related stress. CONCLUSION: Based on these results, risk maps were drawn for each sector of the radiology department to be used in the implementation of improvements in each sector.

Keywords: Ergonomics, Biosafety, Map risks, Stress, Protective devices

OBJECTIVE: To compare radiological techniques used in Brazil and in Australia, and to evaluate radiation doses of the most common x-ray procedures. MATERIALS AND METHODS: The entrance skin dose (ESD) and the effective dose (ED) were obtained with the software DoseCal. In both countries the study was conducted in large public hospitals. Four distinct procedures were evaluated: chest, abdomen, pelvis and thoracic spine in three views (anterior-posterior, posterior-anterior and lateral) In Australia, all x-ray equipment are digital and linked with PACS whereas in Brazil conventional equipment is used. RESULTS: The mean values of ESD and ED were consistently higher in Brazil, except for chest x-rays. The higher differences were seen in pelvis (26 fold higher in Brazil) and thoracic spine (43 fold higher in Brazil) radiographs. CONCLUSION: All Australian hospitals have quality assurance programs (QAP) implemented on a permanent basis, the most advanced digital equipment and count with an effective medical physics service. These factors are determinant for high quality images, low rejection rates and low doses imparted to patients when compared to Brazilian standards. Theses results reinforce the need of implementation of quality assurance programs in Brazil. However, when analyzing the results of ESD for chest x-rays, we concluded that low doses can also be achieved in Brazil with the use of appropriate x-ray techniques.

Keywords: Entrance skin dose, Radiodiagnosis, Effective dose, Dosimetry

OBJECTIVE: With the aim of reducing and preventing environmental damages, handling and disposing practices of chemical effluents from radiology departments were investigated and a service management model was created in order to obtain financial resources for the department. MATERIALS AND METHODS: The proposed model, based on the evaluation of chemical effluents from automatic processors of radiographic films, showed that fixer reprocessing can be an adequate choice to solve environmental and financial problems in these departments. This model also emphasizes that compliance with management guidelines should be observed, i.e. other effluents (developer and water) must be chemically treated before disposal in the natural environment. The economical analysis has confirmed that the income originated from commercializing the silver (of which concentration ranges from 3.5 to 10.2 g/l), recovered from the used fixer, in addition to the income from the reuse of the fixer (after its recovery), is in the worst scenario (when the silver concentration is 3.5 g/l) enough to cover all the expenses with the implementation of the project. CONCLUSION: The proposed model can be a good choice for solution of environmental and financial problems. Moreover, it is ecologically correct, a potential source of financial resources to radiology departments, and can be applied to other institutions due to the similarity of problems and resources.

Keywords: X-ray film processing, Developer, Fixer, Silver, Natural environment

A computerized system to manage quality control testing and general X-ray equipment maintenance was developed in accordance with the requirements of Brazilian legislation (Ministerial Order No. 453/98). Quality control tests are part of a quality assurance program that should be implemented in all medical and odontological radiodiagnosis institutions. A Microsoft Access® database was developed to allow a direct link with the maintenance system that is being implemented at the "Hospital Universitário Clementino Fraga Filho - Universidade Federal do Rio de Janeiro", Rio de Janeiro, Brazil.

Keywords: Database management systems, Quality control, Radiography

The evaluation of film processing using the STEP test (sensitometric test for the evaluation of processing) is based on the identification of significant deviations in the processor-chemicals-film system. Ideal processing conditions are established for this type of evaluation. A standard film is processed according to the manufacturer's recommendations, i.e. standard processing at 100. The film is exposed to the light of a calibrated sensitometer and the sensitometric steps are read with the use of a densitometer. A standard curve (OD × STEP) is therefore obtained. The percentual deviation should be lower than 20% compared to the standard curve. This method is useful to identify processing problems. We tested processors from several public/university hospitals and found that approximately 33% of the equipments had inadequate processing conditions.

Keywords: Automatic processors, Radiographic films, Sensitometry, STEP test

Quality control tests, according to "Portaria 453/98" of the Brazilian Health Ministry, were applied in seven public hospitals of Rio de Janeiro including 29 X-ray tubes, 30 cassettes and 20 individual protection garments. These tests evaluate mainly the X-ray generator and system geometry. Other tests in the accessories were also performed, such as: cassettes, screens, viewing boxes, darkrooms and clear rooms. In the kVp tests, 55% of the equipments were disapproved in exactitude and 15% in reproducibility. Time exactitude and reproducibility were not approved in 53% and 31% of the equipments, respectively. The percentages of disapprovement were: for the HVL (half-value layer) 30%, for beam alignment 18%, for field coincidence 30%, for exposure linearity 40% and for focal spot 64%. It has also been observed that frequently the lead aprons were not kept in appropriate hangers and this procedure may cause damage to these accessories. The results of the test suggest the need of implementation of quality assurance tests in these services. The cost benefit analysis of the results reinforces the importance of the implementation of the recommendations contained in this paper.

Keywords: Quality assurance, Quality control, Radiodiagnostic

The dose area product was evaluated and the entrance skin dose was subsequently estimated by means of suitable calculations for pediatric examinations. Results showed values around 100% above the reference levels (0.070 mGy). The technical parameters of the X-ray tubes were periodically checked since a routine quality assurance program is implemented in the hospital. Results showed a good performance of the equipment complying with recommended limits according to Brazilian legislation. Therefore, the high doses can be attributed to the low kV techniques and the lack of appropriate training of the radiographers to perform pediatric examinations. Measurements of scattered radiation were performed in the gonads with the use of thermoluminescent dosimeters which proved to be inadequate for these measurements. Therefore an ionization chamber was used instead and the values obtained showed that the doses were far below the values that can cause permanent or transient sterility.

Keywords: Radiation doses, Pediatric radiology, Image quality

We analyzed the dose area product (DAP) of 12 patients submitted to videofluoroscopic swallowing studies. The aim of this study was to establish, in a preliminary manner, the values of radiation exposure for patients submitted to this type of examination. A Diamentor equipment was used to register the cumulative radiation doses emitted by the x-ray tubes. Two different rooms with identical radiological equipment were used to collect the data. The protocol used was rigorously the same and the same experienced professional performed the examinations. DAP's values for the three phases (oral, pharyngeal and esophagogastric) of the videofluoroscopic swallowing study were, for the room A (7 patients), 4,101 cGy.cm², DAP/min. = 577 cGy.cm²/min., and for the room B (5 patients), 804 cGy.cm², DAP/min = 119 cGy.cm²/min. These different results were obtained from patients of the same height and weight, using the same examination time (around 7 minutes) for all patients. We concluded that the data showing doses five times lower in room B are more reliable that those obtained for room A and that DAP and DAP/min. are good elements to inform patient doses imparted by videofluoroscopic swallowing examination. We believe that the high dose differences observed between the two groups are due to lack of calibration of the x-ray equipment, since unfortunately "quality assurance programs" are not routinely implemented.

Keywords: Dosimetry, Videofluoroscopy, Dose area product (DAP), Swallowing

An occupational monitoring program in diagnostic radiology was implemented at the "Hospital Universitário Clementino Fraga Filho - UFRJ", Rio de Janeiro, Brazil, in accordance with the Brazilian legislation. Previously, a survey of all personnel involved with ionizing radiation was performed. Many problems were observed: the great majority of the workers were not properly monitored; only three departments of the hospital kept an independent survey of the occupational doses; there was not a follow-up control of the high doses. With the implementation of the program, a new laboratory was chosen to read the dosemeters and this initiative resulted in reduction of the hospital costs. The inclusion of seven more departments in the program represented an increase of 60% in the number of monitored workers. The program also provided a system to control the high doses, especially in the Hemodynamics department, which presented the highest mean dose value (0.32 mSv/month). An area survey program was performed during different periods in places considered of high risk for the workers and for the public as well. At the same time, a software was used to build a database with the aim of controlling all personnel data. The implementation of the program provided all personnel involved a better knowledge of the risks associated with ionizing radiation and of radioprotection, and also awareness of the need of correct use of the personal dose monitors.

Keywords: Radiological protection, Occupational exposure, Quality control, Radiation dosimetry, Radiology

We compared chest radiographs using high and low kilovoltage techniques with the aim of obtaining best quality techniques as well as a reduction in patient doses. The study was performed in 48 patients randomized that were submitted to 70 postero-anterior chest radiographs using high (120 kVp, 2.3 mAs) and low (70 kVp, 5-10 mAs) kilovoltage techniques. The entrance skin dose values were measured with a Diamentor. The low kilovoltage technique showed a 326% increase of the dose when compared with the high kilovoltage technique. The use of the high kilovoltage technique decreased the number of low quality radiographs that required repetition, thus sparing the equipment and reducing the costs due to best quality radiographic images.

Keywords: Chest radiographs, Dosimetry, Image quality

We developed a management model for maintenance of hospital radiological X-ray equipment. The model was implemented in several steps including visits to other hospitals where equipment management is also done, collaboration work with "Fundação Oswaldo Cruz" for the realization of courses and a training program for the hospital electronic technicians, organization of a small library with the schemes of the radiological equipment in use at "Hospital Universitário Clementino Fraga Filho", Rio de Janeiro, Brazil, development of a management software using a database from Access (Microsoft Windows) and evaluation of the performance of the radiological equipment. The implementation of a new routine for equipment maintenance fulfils the need for reducing repair delay and costs, improving image quality in radiodiagnosis services, and complying with resolution 453/98 of the Brazilian Ministry of Health.

Keywords: Equipment maintenance, Radiography, Database management system

Quality control of automatic processors is an important issue in the implementation of quality assurance programs in diagnostic radiology. A pilot program of quality control for automatic processors using the sensitometric method was implemented in the Radiodiagnosis Service of a University Hospital in Rio de Janeiro, RJ, Brazil. An initial survey of the darkrooms showed that they had high temperature and humidity and several light leaks; fog levels were excessively high requiring an increase in mAs of up to 24% to compensate for contrast loss; dry to dry processing time was out of control with errors of up to 56%; developer temperature was as high as 39°C (4°C higher than the recommended by the manufacturers); replenishment rates presented values as high as 417% above manufacturer's recommendations; and rejection rates of radiographic films were of the order of 21% in the mammography service. Sensitometric measurements performed before the implementation of the quality control showed values of base + fog as high as 0.24 optical density and speed and contrast outside recommended limits. The radiographic films presented several artifacts that resulted in low quality images. The pilot program consisted of the implementation of the quality control in the mammography service. Several initiatives were taken including training of the technicians, improvement of maintenance of the processors and increase in the number of patients/day from 7 to 12. This procedure allowed replenishment rates to be lowered to acceptable levels. The implementation of the quality control maintained chemical products stable keeping the sensitometric parameters under control. However, the most significant result of the program was better image quality, free from artifacts, a significant reduction in costs to the hospital and especially lower doses imparted to the patients due to the reduction in rejection rates to 7.7%.

Keywords: Quality control, Automatic processors, Sensitometric method

OBJECTIVE: To evaluate the evolution of mammographic image quality in the state of Rio de Janeiro on the basis of parameters measured and analyzed during health surveillance inspections in the period from 2006 to 2011. MATERIALS AND METHODS: Descriptive study analyzing parameters connected with imaging quality of 52 mammography apparatuses inspected at least twice with a one-year interval. RESULTS: Amongst the 16 analyzed parameters, 7 presented more than 70% of conformity, namely: compression paddle pressure intensity (85.1%), films development (72.7%), film response (72.7%), low contrast fine detail (92.2%), tumor mass visualization (76.5%), absence of image artifacts (94.1%), mammography-specific developers availability (88.2%). On the other hand, relevant parameters were below 50% conformity, namely: monthly image quality control testing (28.8%) and high contrast details with respect to microcalcifications visualization (47.1%). CONCLUSION: The analysis revealed critical situations in terms of compliance with the health surveillance standards. Priority should be given to those mammography apparatuses that remained non-compliant at the second inspection performed within the one-year interval.

Keywords: Mammography; Breast neoplasms; Quality assurance; Health care; Quality control; Public health surveillance.